Description
HA Active-Active mode scenario:
It is a requirement to set HA so that one FortiGate will handle more traffic then the other FortiGate.
For example, the Primary unit carrying more of the load than the subordinate unit.
Note.
This only applies to antivirus scanned sessions.
On the Primary unit CLI, enter the following command:
# config sys ha
set schedule weighted-round robin
set weight 3 1
end
The Primary unit will carry three times the amount of the session traffic than the subordinate unit in HA active-active mode.
To reverse this, use a weight of '1 3', or any other desired combination.
