DescriptionWireless client moved to wired side.
ScopeKB ARTICLE TYPE: Troubleshooting
RELATED PRODUCTS: NA
RELATED SOFTWARE VERSIONS: All versions
KEYWORDS: G1 G2 interfaces
SolutionThe error "Client moved to wired
side" appears when there is a network loop.This may be observed when the
controller is configured for dual bonding. The second interface
configured for guest network is connected to the same switch. G1 and G2
interfaces are connected to the same switch. The client, who connects to
the wireless network will appear in wired side in two
minutes.
Note: The recommended configuration for
G2 is to connect this interface for external network. Make sure these
ports are not going to connect each
other.
