Created on 10-13-2016 07:01 AM Edited on 06-08-2022 01:09 PM By Anonymous
Description
This article will describe a step that may be missed by users when they are trying to configure EMC Clariion.
With the information provided below, Look at values for Prct Busy and Prct Idle. If the values here are "not available", then you have not completed step 6 of the configuration for EMC Clariion.
Getting to the last Step of EMC Clariion's configuration there's a test against the Remote Storage Device:
[admin@B2945-Collector tmp]$ /opt/Navisphere/bin/naviseccli -h xxx.xxx.xxx.xxx -User xxxxxxxxx -Password xxxxxxx -Scope global getall -sp SP Information -------------- Storage Processor: SP A Storage Processor Network Name: xxxxxxxxxxxx Storage Processor IP Address: xxx.xxx.xxx.xxx Storage Processor Subnet Mask: 255.255.255.0 Storage Processor Gateway Address: xxx.xxx.xxx.xxx System Fault LED: OFF Statistics Logging: OFF SP Read Cache State Enabled SP Write Cache State Enabled Max Requests: N/A Average Requests: N/A Hard errors: N/A Total Reads: 0 Total Writes: 0 Prct Busy: Not Available Prct Idle: Not Available System Date: 09/18/2013 Day of the week: Wednesday System Time: 13:19:37 Read_requests: 0 Write_requests: 0 Blocks_read: 0 Blocks_written: 0 Sum_queue_lengths_by_arrivals: 0 Arrivals_to_non_zero_queue: 0 Hw_flush_on: 0 Idle_flush_on: 0 Lw_flush_off: 0 Write_cache_flushes: 0 Write_cache_blocks_flushed: 0 Internal bus 1 busy ticks: N/A Internal bus 1 idle ticks: N/A Internal bus 2 busy ticks: N/A Internal bus 2 idle ticks: N/A Internal bus 3 busy ticks: N/A Internal bus 3 idle ticks: N/A Internal bus 4 busy ticks: N/A Internal bus 4 idle ticks: N/A Internal bus 5 busy ticks: N/A Internal bus 5 idle ticks: N/A Controller busy ticks: 0 Controller idle ticks: 0
Here is Step 6 from the Configuration/User's Guide:
Make sure that the Analyzer module is on - otherwise the performance metrics will not be available and discovery will fail.
Here is what those two Values should look like:
Prct Idle: 0 Prct Busy: 0
Please go through Step 6 on your EMC Clariion and turn on the Analyzer Module.
When running the naviseccli command, put the IP of the Storage Processor and not the Control Station.
ALL
The Fortinet Security Fabric brings together the concepts of convergence and consolidation to provide comprehensive cybersecurity protection for all users, devices, and applications and across all network edges.
Copyright 2024 Fortinet, Inc. All Rights Reserved.