DescriptionThis article provides best practices for adding and removing DHCP scopes used in isolation networks.ScopeVersion: AllSolutionDHCP scopes should be added and removed using the Configuration Wizard. Refer to the applicable hardware install guide in the Fortinet Document Library for instructions on adding DHCP scopes using Configuration Wizard.
Appliance Installation
VMware Virtual Machine Installation
Hyper-V Virtual Machine Installation
For L2 Network Configurations (isolation VLANs tagged back to eth1 isolation interface) refer to the chapter "Layer 2 Network - Configure VLANs".
For L3 Network Configurations (isolation VLANs on separate networks and routed to eth1) refer to the chapter "Layer 3 Network - Route Scopes".
If Configuration Wizard cannot be run due to customized configurations, contact support for assistance.
Related Articles
Technical Note: Manually add DHCP scopes via CLI - INTERNAL