Description
This article describes how to configure Huawei Switch to Support VOIP Phone and PC on the Same Port.
Solution
Below is an example of how to configure the Huawei Switches to support an IP Phone and a data device on the same switch. This will allow the IP Phone to be on the trunk port and the data VLAN to be managed by FortiNAC.
Note: The syntax used may vary depending on the firmware version of the switch. Refer to vendor documentation.
In this example, the following values are used:
Voice VLAN ID = 12 (Voice VLAN is tagged).
Data VLAN = 242 (Data VLAN is untagged).
Interface GigabitEthernet0/0/28
description HELICA voice-vlan 12 enable voice-vlan remark-mode mac-address voice-vlan mode auto port hybrid pvid vlan 242 undo port hybrid vlan 1 port hybrid untagged vlan 242
