DescriptionDHCP service not starting after appliance has powered up after a power failure in the closet or building.ScopeVersion: AllSolutionVerify eth1 interface of the Server or Application Server has link and is administratively up. In the CLI of the Server or Application Server, run the command:
ip addr show dev eth1
> ip addr show dev eth1
3: eth1: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP group default qlen 1000
...
If eth1 has no link, but the interface is administratively up:
- Verify the switch to which eth1 connects is powered and switch port is working
- Check the cabling connecting eth1 and switch port
Related Articles
Technical Note: DHCP service running but isolated hosts do not get IP
Technical Note: Troubleshooting DHCP for isolation VLANs