Support Forum
The Forums are a place to find answers on a range of Fortinet products from peers and product experts.
BusinessUser
Contributor

SDWAN SLA Question

Suppose the jitter and latency is in the red but the packet loss is 0,

under what circumstances will the firewall declare the link down and remove static route from the routing table?

I configured the SLA by the way.

 

My users are video streaming and the latency and jitter of wan 1 and wan 2 is high, although the packet loss is 0.

Will the links be declared dead? 

1 Solution
mpeddalla

Hello @BusinessUser ,

 

You can refer to the below links by default the performance parameters are set as below article 

https://docs.fortinet.com/document/fortigate/6.2.15/cookbook/382233/performance-sla-sla-targets

https://docs.fortinet.com/document/fortigate/7.0.0/sd-wan-sd-branch-deployment-guide/575336/defining...

 

but you can adjust them as suggested by @funkylicious using sla parameters you choose.

Technical Tip: SD-WAN Best Quality (SLA) Customize... - Fortinet Community

 

-There will be different parameters you can choose under sd-wan rules 

https://docs.fortinet.com/document/fortigate/7.0.0/sd-wan-sd-branch-deployment-guide/727336/creating...

 

Manual, Best quality, SLA, maximum SLA  each one has a different mechanism. Most customers would prefer the automatic SLA process by best quality as it updates the routing table based on WAN interface availability.

 

Regards,

Manasa

 

 

View solution in original post

4 REPLIES 4
lgupta
Staff
Staff

Hello,
This totally depends on how have you configured the SLA targets in the  Performance SLA section. Also, it depends on which Interface Selection Strategy (especially when using COST) you are using in SDWAN rule. The settings are very much granular.


You may have to set up a lab and test out on how the SLA Thresholds and Intf. selection Strategy helps your case.

 

Thanks

-Lakshay

Best regards,

-lgupta



If you feel the above steps helped to resolve the issue mark the reply as solved so that other customers can get it easily while searching on similar scenarios.
BusinessUser

What if I did not put anything in the Performance SLA section meaning that i leave it default?

 

How do I know the parameters for good sla threshold?

funkylicious

geek
mpeddalla

Hello @BusinessUser ,

 

You can refer to the below links by default the performance parameters are set as below article 

https://docs.fortinet.com/document/fortigate/6.2.15/cookbook/382233/performance-sla-sla-targets

https://docs.fortinet.com/document/fortigate/7.0.0/sd-wan-sd-branch-deployment-guide/575336/defining...

 

but you can adjust them as suggested by @funkylicious using sla parameters you choose.

Technical Tip: SD-WAN Best Quality (SLA) Customize... - Fortinet Community

 

-There will be different parameters you can choose under sd-wan rules 

https://docs.fortinet.com/document/fortigate/7.0.0/sd-wan-sd-branch-deployment-guide/727336/creating...

 

Manual, Best quality, SLA, maximum SLA  each one has a different mechanism. Most customers would prefer the automatic SLA process by best quality as it updates the routing table based on WAN interface availability.

 

Regards,

Manasa

 

 

Labels
Top Kudoed Authors