Description This article describes how to move the order local-in policy
to block traffic and delete existing policies. Scope FortiGate v6.4.x,
v7.0.x and above, Solution In the below example, we are creating two
policies allowing all IP addresses fr...
Description This article describes how to create custom port services
from GUI and how to add them to firewall policy when there is a
requirement to use. Scope FortiGate. Solution As shown in the below
image, select policy & object and choose Service...
Description This article describes how to create a loopback interface
for FortiSwitch CLI and make sure communication between both loopback
interfaces on FortiGate and FortiSwitch works. Scope FortiGate v7.0.x
and higher. Solution There will be a sit...
Description This article describes how to create a loopback interface
from FortiGate GUI. Scope FortiGate. Solution Go to Network ->
interface, select 'Create new' and choose Interface. Give a name for the
interface and then choose the type drop-down...
Description This article describes how to create a static route on
FortiGate from the GUI Interface. Scope FortiGate. Solution In GUI, go
to Network -> Static Routes and select 'Create New'. As shown in the
below diagram, give the destination address...
Hello @dzequimassai , Thank you for contacting the Fortinet Forum
portal. Can you please if the device is on HA ? there is a known issue
on 7.2.7 to view logs for fortianalyzer ID : 932537
https://docs.fortinet.com/document/fortigate/7.2.7/fortios-re...
Hello , Thank you for contacting the Fortinet Forum portal. I would
recommend to verify first which topology scenario comes under and then
start troubleshooting after checking configuration.
https://docs.fortinet.com/document/fortigate/7.4.3/administ...
Hello @ganesh_karale , Thank you for contacting the Fortinet Forum
portal. can you confirm the model of Fortiap which you are using along
with the firmware version? So that we can check the datasheet of the AP.
-As earlier confirmed by my colleague t...
Hello @unknown1020 , Thank you for contacting the Fortinet Forum portal.
I would suggest verifying which process is taking memory either
ipsengine or ipshelper or wad and then adjusting the counter engine
count which would limit the process usage. -A...
Hello @AEK , Thank you for contacting the Fortinet Forum portal. We
always encourage customers to verify release notes before upgrading to
any version. The article gives general suggestions that sometimes the
firmware could vary depending on the envi...