Description This article describes how FortiGate determines which RADIUS
Server will receive the RADIUS Accounting logs. Scope FortiGate version
7.4.3. Solution If FortiGate has multiple RADIUS Accounting servers, by
default FortiGate will only send ...
Description This article describes how to delete VDOM from CLI. Scope
FortiGate. Solution There may be a scenario where it is impossible to
access the FortiGate GUI and there is a requirement to delete the VDOM.
But usually, it is not an easy task, b...
Description This article describes the behavior modification of how
FortiOS determines the SD-WAN member order when using the Lowest Cost
(SLA) Algorithm. Scope FortiGate v6.4.10 and v 7.0.9 and later. Solution
The scenario is as explained below: Spo...
Description This article describes how to solve the IPSec negotiation
issue between Fortigate and WatchGuard. Scope FortiGate, WatchGuard.
Solution If FortiGate is behind the NAT device, it needs to be tweaked
on IPSec setting if trying to connect wi...
Description This article describe how to configure LDAP Setting on
FortiProxy when integrating with Cisco UCS LDAP Server Scope FortiProxy
v7.0.8. Solution Based on the article below, in some cases, it is
required to strip a domain string from the UP...
The numbers on datasheet was done on lab environment and those are only
a benchmark of what the hardware could possibly handle. But I believe
only Fortigate product team know exactly how the test was done. For any
capacity planning enquiries, I would...
you can create VLAN interface (tagged interface) under that one physical
interface
https://community.fortinet.com/t5/FortiGate/Technical-Tip-How-to-create-a-VLAN-tagged-interface-802-1q-on-a/ta-p/193893
after that you can specify the default route,wh...
few articles you can read up about it :
https://community.fortinet.com/t5/Support-Forum/why-do-we-assign-secondary-IP-address/m-p/219857
https://community.fortinet.com/t5/FortiGate/Technical-Tip-Set-a-secondary-IP-on-a-FortiGate-interface/ta-p/226046
Based on the available command you shared, I don't think it's possible.
Once the ports are member of LACP interface, most likely that older
version can't refer to the physical port anymore.
It's a bit tricky to set management access on FGT Transparent Mode. You
may want to check docs send by Minh for more detailed deployment.
Usually when you have multiple VLAN going through FGT, you need to
define forward domain. So the traffic will no...