Description This article describes how to resolve an issue experienced
on a 7000F series when the CLI on the FIM shows a mismatch message
'Error: FIM1 and FIM2 boardtype mismatch detected!' during the boot
process: ----------------------------------R...
Description This article describes how to power-off/power-on any slot on
a FortiGate 7000 series from the Shelf Management Module (SMM). This
procedure may be useful in situations where one or more FPMs did not
restart correctly following a power out...
Description This article describes how FortiGate calculates the BFD
Transmit Interval and Detection Time in a BFD peering connection. Scope
FortiGate v5.6 and above. Solution The Bidirectional Forwarding
Detection (BFD) is a network protocol used to ...
Description This article describes how to collect logs for
troubleshooting purposes after a PSU failure occurs on a FortiGate 7000E
series chassis. Scope FortiGate 7000E series Shelf Manager Module (SMM).
Solution This article contains useful command...
Description This article describes how to configure SNMP v3 on a HA
cluster of FortiGate 6000 or 7000 Series with the purpose of monitoring
each individual slot of cluster members. Scope FortiGate 6000 and 7000
series on v5.6 and above. Solution Prer...
Hi @Avyner , The links below might help
you:https://docs.fortinet.com/document/fortigate/7.4.3/administration-guide/131140/replacement-messages#Modifyinhttps://docs.fortinet.com/document/fortigate/7.4.3/administration-guide/934626/captive-portalsBest...
Hi @Faresnani , My understanding is that you are having some traffic
passing through even if you are blocking the facebook domain access in
the applied UTM profiles. It happens with some browser only (.i.e.
Chrome), while other browsers are being blo...
Hi @Nkom , When you say "it stops working", what do you mean? Please
provide more details, that is too general.1- Does FortiGate still
process some traffic when the issue happens?2- Can you access it? Or can
you access its console at least?3- Does it...
Hi @Umesh, Please have a look at the article
below:https://community.fortinet.com/t5/FortiGate/Technical-Tip-Cannot-provision-FortiToken-Mobile-due-to-error/ta-p/192610Best
regards,
Hi @ShaileshMdr, Assuming that IPsec phase 1 and 2 are up and running,
it seems that the routing may be not properly configured somewhere.The
problem might be on the other side of the IPsec tunnel, do you control
the remote peer as well?You could run...