hi, today I set up email alerts for various events (so, event based and
not severity level based), and I am missing a setting for hardware
failure events, you know, fans, PSU, temperature. A look into the CLI
didn't help.Am I thinking too hard, and t...
Hello fellows, for simplicity, I often use my private SSH key to log in
into my local admin account on various FGTs (I mean, CLI access via
SSH). Now, if instead of a local admin account I use a wildcard admin
account against LDAP/MS AD in the backgr...
hello all, I've got a pair of FG-200B running v4.3.18 in A-P HA mode.
Each cluster member is at a different location, HA links are across a
dedicated line. On each site, there is one Cisco access router (19xx) in
front of the FGT providing WAN access...
hello all, I'm planning to place the slave unit of a Fortigate HA
cluster into a remote location. There is a leased line (layer 2) for the
HA connect. Can anybody confirm that I can run the HA traffic across a
VLAN between the access switches on each...
I'm irritated by the prompt as well: "(global)". You would only have a
global mode if VDOMs were allowed. Are you sure you are not in VDOM mode
yet?from any prompt:endendconfig vdomedit ? This will display any
existing VDOMs (without creating any).Pl...
If this only occurs after a tunnel failure (due to power outage), it
might be that tunneled traffic is sent out of the WAN interface instead
of the tunnel IF. Put in a blackhole route for the private address range
you use. It will not harm during nor...
@RolandBaumgaertner72 wrote:Hi,Thanks for the fast response. We dont
have access to the SW but we know that the VPN FG<>SW is working. So
first I wanted to be sure, that from our site everything is OK.Thanks We
dont have access to the SWSo if traffic...
Well, that points to the router a lot, doesn't it? I'd collect longterm
ping statistics and open a call with the ISP. If the router locks up
after a couple of days then it needs to be replaced.No FGT topic though.
Without going into too much detail, try to see the FGT as a router
first, and then add policies because it is a firewall in addition.Your
ultimate goal probably is to connect the PCs to the cloud service. So,
for routing to happen, each hop needs to ...