Description This article describes how to increase the L2TP IP Pool.
Scope FortiGate. Solution L2TP IP Pool can only be edited via CLI.In the
below example, the L2TP IP Pool only has IPs from 192.168.50.1 to
192.168.50.5. FGT # show full-configuratio...
Description This article describes actions to consider when performing a
FortiGate firmware upgrade from the FortiGate Cloud Portal. Scope
FortiGate, FortiGate Cloud/ Solution Firmware upgrade from FortiGate
Cloud Portal is only available for devices...
Description This article describes the effects of route priority on PING
operations from the FortiGate CLI. Scope FortiGate. Solution
Network:FortiGate has two WAN interfaces - Port1 and Port2.
IP=10.47.1.80->10.47.1.80/255.255.240.0 index=3
devname=...
Description This article describes why users may find implicit SD-WAN
rule IDs not missing due to changes made to the session list output.
Scope FortiOS 7.0.4+. Solution If traffic hits an implicit SD-WAN Rule,
it means the session was handled using ...
Description This article describes how to allow access to only specific
file(s) from Google Docs and block others. Scope FortiGate. Solution
Below are the requirements to allow access to specific file(s) list from
Google Docs and block others. Web Fi...
Hi @jpever ,Fortigate on HA (A-P and A-A) will be having same
configuration. Thus, the IP address configured on FW1 will be the same
with FW2.IP addresses will be active on Primary Firewall.If primary
firewall fails, the secondary device will take ov...
Hi Umesh,You may refer to below guide and
documentation.https://community.fortinet.com/t5/FortiGate/Technical-Tip-FortiGate-HA-upgrade-procedure-and-the-status/ta-p/246692https://docs.fortinet.com/document/fortigate/7.4.3/administration-guide/247944I...
Hi,Virtual IP with Port Forwarding is needed.You may refer to below
guide on how to configure
it.https://docs.fortinet.com/document/fortigate/7.4.3/administration-guide/155333/virtual-ips-with-port-forwardingNote
you need to configure 1 set of VIP pe...
On my understanding, your connection is something like this. Building B
have primary ISP and you want all traffic to failover to FTT_Building_A
when building B ISP went down.The configuration should consist of:FGT
A:1. Firewall policy from Port2 goin...