Hi all, I'm checking a new dial up IPSEC tunnel using forticlient and it
works fine but it goes down suddenly. I've checked all parameters and
they are apparently fine (key life time etc). I have done a debug and we
can see a message that could be th...
Hi all, I have observed that, when I enable deep inspection in proxy
mode to protect my web servers, the SSL check of SSL check pages not
pass. Obviously, I use the same certificate in Both cases. In browsers,
I see perfectly the certificates.On the ...
Hi all,I have create an IPSEC dial up tunnel with Ike v2 and NAT-T. I
use Forticlient to connect to it and it works well. I have observed that
some traffic are denyed cause when I send traffic across the tunnel, the
user with witch Im logged (using f...
Hi all, I've several FortiAp registered in FortilanCloud and all is
working well. These APs are connected to Fortiswitch and Fortiswitch is
connected to Fortigate. These APs are connected to an interface with
security fabric enable. If I check in For...
Hi all ¡¡ I'm trying to configure an email alert when WAN2 interface
from my fortigate with 7.0.11 goes dow, but its not working. Probably
I'm forgetting some steps or doing something wrong. This is the article:
Technical Tip: E-mail alert when WAN i...
For the moment it works fine afther that I have updated forticlient
agent. Currently Im the only user of the tunnel, I'm checking it. With
Ike v1 I didn't have the problem but the tunnel was not exactly the
same.I will mantain you informed but I thin...
Hi hbac. Ikev2 is recommended whenever possible. Could you confirm me
that with this protocol I have that limitation? I am surprised cause I
thought that Ikev1 is an evolution of ikev2.
Thanks hbac. This tunnel was Ikev1 and it has worked fine with users.
But I would like to upgrade it to v2 to do it more strong and secure. I
tought that ikev2 was better than v1. You cannot filter by groups using
v2? Thanks ¡¡¡