Description This article describes how to allow Windows operating system
PC/Laptop to internet and block other operating systems. Scope FortiOS
7.4. Solution Go to System -> Feature Visibility -> enable 'Dynamic
Device & OS Identification'. Go to the...
Description This article describes how to enable voice-enterprise under
wireless-controller vap profile. Scope FortiGate Wireless controller.
Solution The below example shows two vap profiles configured: config
wireless-controller vap edit "vap1" set...
Description This article explains an error where an ADVPN shortcut
cannot be created. During this issue, the forward shortcut-query shows
as '0000000000000000' when queried. Scope FortiGate, ADVPN. Solution Run
the following command on the HUB firewa...
Description This article describes the traffic shaping destination using
ISDB. Scope FortiGate. Solution FortiGate traffic shaping profile can
configure destination using ISDB object. In this example, the limits of
Anydesk file transfer speed will be...
Description This article describes how to block TeamViewer using the
ISDB firewall policy. Scope FortiGate. Solution Create a firewall policy
on top with destination choosing Internet Service -> filter with word
'TeamViewer' and choose 'TeamViewer-Te...
Hello martyyy, You need to make sure the speed/duplex on that wan port
that you going to upgrade had auto negotiate/hard code to 1Gbps/full
duplex. If not when the speed had upgraded to 200Mbps, the speed will
cap at 100Mbps.
Hello, You can run packet sniffer to verify whether got incoming IPSEC
traffics or not. Below are the command: diagnose sniff packet any "port
500 or port 4500" 4 0 Then try connect IPSEC from your PC and see got
any output or not. If no output, that...
Hello, You can run packet sniffer on Fortigate and verify whether got
incoming traffics or not. Below is the command: diagnose sniff packet
any "port 3390" 4 0 If you did not see any output, it might block by
upstream device.