Hello team!!! I hope it goes well for you!We have 2 different "trunk"
interfaces (With different VLANs on each one).For example:* VLANs 10, 20
and 30 on port1* VLANs 40, 50 and 60 on port2Now, we need to add the
VLAN 100 in both trunks interfacesBeca...
Hello team!!! We manage many Fortigates in different sites and recently
upgraded all to 7.4.3After this, we have problem accessing to some
fortigates through some wan interfacesFor example I can access through
wan2 but not through wan1, or in other c...
Hello team!!! I hope you are fine!I have the following question, if I
configure an sd-wan rule with the "maximize bandwidth" strategy,
configuring in the cli, the "set hash-mode inbandwidth", how fortigate
determines the interface with most available...
Hello team!!! Recently a Fortinet engineer told me that performance SLA
are not considered if there are not explicit rule including them, so I
wonder how to create a Load balance, using both WANs in the SD-WAN,
taking care about the bandwith of each ...
Hello team!!! When I configure a new "Performance SLA", in the "Packet
Loss threshold" option I can set the maximum packet loss to consider a
link as "Up" but I dont know how many time or cheks are used to get the
value.I mean, with a low value, it i...
Hello, Just to know before try this, just if you already know the
answer:Should this work without any rule to allow traffic, right? (In
layer 2, like a switch) ThanksRegards
NOTE: This happened also with a WAN not member of a SD-WAN.Maybe the bug
is not only with SD-WAN members, but this is a bug for sure, because the
issue started after upgrading all to 7.4.3
