Description This article describes how to configure a Loopback interface
in FortiGate and access it for a public IP address. Scope FortiGate.
Solution Configure a loopback interface with an IP address not used in
the Network: config system interface ...
Description This article explains the meaning of the number in the URL
field for VDOMs. Scope FortiGate, VDOMs. Solution Specific number #
inserted before ?vdom=root represents the virtual link that has the GUI
dashboard for each VDOM. /ng/system/das...
Description This article describes how to allow specific IPS app
signatures in case other IPS alerts are needed. Scope FortiGate all
firmware.It is possible to allow IPS traffic in the IPS profile by
changing the action of the profile. Solution To al...
Dear @RolandBaumgaertner72 Please check the below doc related to your
issue:
https://docs.fortinet.com/document/fortigate/6.2.12/fortios-release-notes/413989/fortigate-30e-and-5...
https://community.fortinet.com/t5/FortiGate/Troubleshooting-Tip-How-t...
Dear @Alkosto1 , Please if you make a hard failover the Security profile
is shown in the New Primary (Old Secondary)? execute ha failover set 1
Caution: This command will trigger an HA failover. It is intended for
testing purposes. Do you want to con...
Dear @ArnaudL Please can you disable IPv6 on the NIC of the client
machine and try again. Please follow the KB -
https://community.fortinet.com/t5/FortiGate/Technical-Tip-SSL-VPN-fails-at-98/ta-p/248363
Best regards, Erlin
Hi @Krmw Please run the below command to check which is the policy that
should match in the FortiGate # diag firewall iprope lookup
Please refer
to the KB for more details -
https://community.fortinet.com/t5/FortiGate/Technical-Tip-Trace-which-f...
Hi Sebastian, For the WAN 2 are you able to ping the gateway for WAN 2?
If you are not able to ping it, that the problem is with the provider. #
execute ping-options interface WAN2 # execute ping
Best regards, Erlin
