Description This article describes how to sync out-of-sync HA devices
after a firmware upgrade. Scope FortiGate. Solution There would be a few
scenarios post-upgrade of FortiGate HA devices, where the secondary HA
device is not in sync with the prima...
Description This article describes how to move the order local-in policy
to block traffic and delete existing policies. Scope FortiGate v6.4.x,
v7.0.x and above, Solution In the below example, we are creating two
policies allowing all IP addresses fr...
Description This article describes how to create custom port services
from GUI and how to add them to firewall policy when there is a
requirement to use. Scope FortiGate. Solution As shown in the below
image, select policy & object and choose Service...
Description This article describes how to create a loopback interface
for FortiSwitch CLI and make sure communication between both loopback
interfaces on FortiGate and FortiSwitch works. Scope FortiGate v7.0.x
and higher. Solution There will be a sit...
Description This article describes how to create a loopback interface
from FortiGate GUI. Scope FortiGate. Solution Go to Network ->
interface, select 'Create new' and choose Interface. Give a name for the
interface and then choose the type drop-down...
Hello @HariE , Thank you for contacting the Fortinet Forum portal. I
recommend checking the configuration and upload the topology diagram and
traffic flow.
https://community.fortinet.com/t5/FortiGate/Technical-Tip-Configuring-Hairpin-NAT-VIP/ta-p/195...
Hello @morana , Thank you for contacting the Fortinet Forum portal.
Whatever mode you use make sure the arp entry is present in the arp
table of the FortiGate to ensure the next hop route. -Did you verify
with the ISP the same information as to why t...
Hello @andej , Thank you for contacting the Fortinet Forum portal. As
@ozkanaltas mentioned, most problems would be compatibility of the SPF
or speed. please refer below links to verify the transceiver on
fortiswitch and fortigate and to adjust the s...
Hello @dzequimassai , Thank you for contacting the Fortinet Forum
portal. Can you please if the device is on HA ? there is a known issue
on 7.2.7 to view logs for fortianalyzer ID : 932537
https://docs.fortinet.com/document/fortigate/7.2.7/fortios-re...
Hello , Thank you for contacting the Fortinet Forum portal. I would
recommend to verify first which topology scenario comes under and then
start troubleshooting after checking configuration.
https://docs.fortinet.com/document/fortigate/7.4.3/administ...
